Family: extreme boss (v6.2.0)
==================================================
Vendor: extreme
Family: boss
New: No

CLI Commands:
--------------------------------------------------
  STP: show spanning-tree mstp port config
  Routing table: show ip
  Routing table: show vlan
  SN: show sys-info
  STP: show mlt
  STP: show sys-info
  STP: show vlan interface vids
  STP: show running-config
  STP: show spanning-tree mode
  STP: show spanning-tree op-mode
  STP: show spanning-tree mstp config
  STP: show spanning-tree mstp msti config <id>
  STP: show spanning-tree mstp msti port config <id>
  STP: show spanning-tree mstp msti port role <id>
  STP: show spanning-tree mstp msti port statistics <id>
  Routing table: show vlan ip
  STP: show spanning-tree mstp port role
  STP: show spanning-tree mstp port statistics
  STP: show spanning-tree mstp status
  STP: show spanning-tree mstp statistics
  STP: show spanning-tree rstp config
  STP: show spanning-tree rstp port config
  STP: show spanning-tree rstp port role
  STP: show spanning-tree rstp port statistics
  STP: show spanning-tree rstp statistics
  STP: show spanning-tree rstp status
  STP: show spanning-tree stp <id> config
  STP: show spanning-tree stp <id> port vlans
  Vlan: show vlan
  L2 Interfaces: show vlan interface vids
  Initial device discovery: show sys-info
  Initial device discovery: terminal length 0
  AAA: show password security
  ARP: show arp-table
  Device info: show sys-info
  Device info: show memory-utilization
  Device info: show lldp local-sys-data
  Device info: show system verbose
  Device info: show telnet-access
  Current config: show running-config
  DNS resolver: show ip dns
  L2 Interfaces: show interfaces verbose
  L2 Interfaces: show port statistics
  L2 Interfaces: show vlan interface info
  Disable pagination: terminal length 0
  L2 Interfaces: show mlt
  L2 Interfaces: show jumbo-frames
  L2 Interfaces: show lldp local-sys-data
  L3 Interfaces: show vlan ip
  L3 Interfaces: show jumbo-frames
  L3 Interfaces: show ip
  L3 Interfaces: show vlan
  MAC: show mac-address-table
  MAC: show mac-address-table vid <vid>
  MAC: show vlan
  Neighbors: show lldp neighbor
  Neighbors: show lldp neighbor-mgmt-addr
  Routing table: show ip route

Task Support:
--------------------------------------------------

  Basic discovery:
    ✓ ARP
    ✓ Device info
    ✓ Disable pagination
    ✗ FHRP
    ✓ Initial device discovery
    ✗ IPv6 Neighbor Discovery
    ✓ L2 Interfaces
    ✓ L3 Interfaces
    ✗ Link aggregations
    ✓ MAC
    ✓ Neighbors
    ✓ Routing table
    ✓ SN
    ✓ STP
    ○ Virtual Contexts
    ✓ Vlan

  Configuration:
    ○ Configuration saved
    ✓ Current config
    ○ Startup config

  Hardware:
    ○ Cluster
    ○ Extenders
    ✗ PoE
    ✗ Power supplies & fans
    ✗ Stacking
    ✗ Transceivers
    ○ VSS

  Management:
    ✗ DHCPv4 Relays
    ○ DHCPv4 Servers
    ✓ DNS resolver
    ✗ IP Flow
    ○ License
    ✗ NTP
    ✗ Port mirroring
    ○ PTP
    ✗ SNMP
    ✗ Syslog
    ✗ Unidirectional Link Detection

  MPLS:
    ○ Circuit cross-connect
    ✗ MPLS forwarding
    ✗ MPLS LDP
    ○ RSVP
    ○ VPLS
    ○ VPWS

  Multicast:
    ✗ IGMP
    ✗ IGMP Snooping
    ✗ MAC multicast address table
    ✗ MROUTE
    ✗ PIM

  Other:
    ✗ PPPoE

  Policy:
    ✗ NAT44

  QoS:
    ✗ QoS

  Routing:
    ○ Fabric Path
    ○ Policy-based Routing
    ✗ Route summary
    ○ Routing policies
    ○ VRF

  Routing protocols:
    ✗ BGP
    ○ EIGRP
    ✗ IS-IS
    ✗ OSPF
    ✗ OSPFv3
    ✗ RIP

  SDN:
    ○ APIC
    ○ Cisco ACI
    ○ Virtual machines
    ○ VXLAN

  SDWAN:
    ○ SD-WAN sites

  Security:
    ✗ AAA
    ○ ACL
    ✗ DHCPv4 Snooping
    ○ DMVPN
    ✗ Error disabled interfaces
    ○ IPsec
    ○ NAT
    ○ Prefix lists
    ✗ Secured access ports
    ✗ Storm control
    ✗ STP port security
    ○ Virtual servers
    ○ Zone firewall

  Wireless:
    ○ Wireless AP
    ○ Wireless APs
    ○ Wireless clients

All Families from extreme:
--------------------------------------------------
  extreme@boss <-- current
  extreme@enterasys
  extreme@voss
  extreme@exos

Legend: ✓=Full, ✗=Not Yet, ○=N/A