Family: paloalto (v4.4.2)
==================================================
Vendor: paloalto
New: No

CLI Commands:
--------------------------------------------------
  Syslog: show config merged
  Neighbors: show lldp neighbors all
  NTP: show ntp
  OSPF: show routing protocol ospf interface
  OSPF: show routing protocol ospf neighbor
  OSPF: show interface all
  OSPF: show interface <name>
  Link aggregations: show interface all
  Link aggregations: show lacp aggregate-ethernet all
  Routing table: show routing route
  Routing table: show routing route virtual-router <vr>
  Routing table: show interface <intName>
  Routing table: show interface all
  Routing table: show interface management
  SN: show mac all
  MAC: show vlan all
  Transceivers: show system state filter-pretty sys.s*.p*.phy
  Transceivers: show system state filter-pretty sw.dev.runtime.ifmon.port-states
  Transceivers: show interface <INT>
  Transceivers: show interface all
  Vlan: show vlan all
  VRF: show interface <int>
  VRF: show interface all
  Zone firewall: show config pushed-shared-policy vsys <vsysName>
  Zone firewall: show interface <intName>
  Zone firewall: show interface all
  Zone firewall: show config merged
  Zone firewall: request system fqdn show
  Zone firewall: show dns-proxy fqdn all
  Zone firewall: show object dynamic-address-group all
  IPsec: show vpn gateway
  AAA: show config merged
  ARP: show arp all
  ARP: show arp management
  BGP: show routing protocol bgp peer
  BGP: show routing protocol bgp summary
  Virtual Contexts: show system state filter sw.mprelay.s1.dp0.vsys.stats.session
  Virtual Contexts: show config merged
  Device info: show system info
  Device info: show system services
  Device info: show system resources
  Device info: show high-availability state
  Current config: show config running
  Power supplies & fans: show system environmentals
  IPsec: show vpn flow tunnel-id <id>
  Disable pagination: set cli scripting-mode on
  IPsec: show vpn ike-sa
  IPsec: show vpn ipsec-sa
  IPsec: show vpn tunnel
  IPsec: show interface <name>
  IPsec: show inteface all
  L2 Interfaces: show interface all
  L2 Interfaces: show interface <int>
  L2 Interfaces: show interface management
  L2 Interfaces: show system state filter-pretty sw.dev.runtime.ifmon.port-states
  L3 Interfaces: show interface all
  L3 Interfaces: show interface <int>
  L3 Interfaces: show interface management
  MAC: show mac all

Task Support:
--------------------------------------------------

  Basic discovery:
    ✓ ARP
    ✓ Device info
    ✓ Disable pagination
    ✗ FHRP
    ✓ Initial device discovery
    ✓ L2 Interfaces
    ✓ L3 Interfaces
    ✓ Link aggregations
    ✓ MAC
    ✓ Neighbors
    ✓ Routing table
    ✓ SN
    ○ STP
    ✓ Virtual Contexts
    ✓ Vlan

  Configuration:
    ○ Configuration saved
    ✓ Current config
    ○ Startup config

  Hardware:
    ○ Cluster
    ○ Extenders
    ○ PoE
    ✓ Power supplies & fans
    ✗ Stacking
    ✓ Transceivers
    ○ VSS

  Management:
    ○ IP Flow
    ○ License
    ✓ NTP
    ✗ Port mirroring
    ○ PTP
    ✗ SNMP
    ✓ Syslog
    ✗ Unidirectional Link Detection

  MPLS:
    ○ Circuit cross-connect
    ○ MPLS forwarding
    ○ MPLS LDP
    ○ VPLS
    ○ VPWS

  Multicast:
    ✗ IGMP
    ○ IGMP Snooping
    ○ MAC multicast address table
    ✗ MROUTE
    ✗ PIM

  Other:
    ✗ PPPoE

  QoS:
    ✗ QoS

  Routing:
    ✗ Route summary
    ✓ VRF

  Routing protocols:
    ✓ BGP
    ○ EIGRP
    ○ IS-IS
    ✓ OSPF
    ✗ OSPFv3
    ✗ RIP

  SDN:
    ○ Cisco ACI
    ○ Virtual machines
    ○ VXLAN

  SDWAN:
    ✗ SD-WAN sites

  Security:
    ✗ AAA
    ○ ACL
    ○ DHCPv4 Snooping
    ○ DMVPN
    ✗ Error disabled interfaces
    ✓ IPsec
    ✗ NAT
    ○ Secured access ports
    ○ Storm control
    ✗ STP port security
    ✗ Virtual servers
    ✓ Zone firewall

  Wireless:
    ○ Wireless AP
    ○ Wireless APs
    ○ Wireless clients

All Families from paloalto:
--------------------------------------------------
  paloalto <-- current
  paloalto@pan-os

Legend: ✓=Full, ✗=Not Yet, ○=N/A