Family: paloalto (v3.8.1)
==================================================
Vendor: paloalto
New: No

CLI Commands:
--------------------------------------------------
  Transceivers: show system state filter-pretty sys.s*.p*.phy
  Neighbor discovery protocols: show lldp neighbors all
  NTP: show ntp
  OSPF: show routing protocol ospf interface
  OSPF: show routing protocol ospf neighbor
  OSPF: show interface all
  OSPF: show interface <name>
  Port-channels: show interface all
  Port-channels: show lacp aggregate-ethernet all
  Routing table: show routing route
  Routing table: show routing route virtual-router <vr>
  Routing table: show interface <intName>
  Routing table: show interface all
  Routing table: show interface management
  SN: show mac all
  Syslog: show config merged
  MAC: show vlan all
  Transceivers: show system state filter-pretty sw.dev.runtime.ifmon.port-states
  Transceivers: show interface <INT>
  Transceivers: show interface all
  Vlan: show vlan all
  Vrf: show interface <int>
  Vrf: show interface all
  Zone firewall: show config running xpath devices/entry[@name="localhost.localdomain"]/vsys/entry[@name="<vsysName>]
  Zone firewall: show predefined application
  Zone firewall: show predefined service
  Zone firewall: show config pushed-shared-policy vsys <vsysName>
  Zone firewall: show interface <intName>
  Zone firewall: show config merged
  Zone firewall: request system fqdn show
  Zone firewall: show dns-proxy fqdn all
  IPsec: show vpn flow tunnel-id <id>
  Init: set cli scripting-mode on
  Init: show system info
  Init: set system setting target-vsys none
  Init: set system setting target-vsys <vsysName>
  ARP: show arp all
  ARP: show arp management
  BGP: show routing protocol bgp peer
  BGP: show routing protocol bgp summary
  Virtual Contexts: show system state filter sw.mprelay.s1.dp0.vsys.stats.session
  Device info: show system info
  Device info: show system services
  Device info: show system resources
  Config Current: show config running
  Environment - Power & Fan: show system environmentals
  Disable pagination: set cli scripting-mode on
  IPsec: show vpn gateway
  IPsec: show vpn ike-sa
  IPsec: show vpn ipsec-sa
  IPsec: show vpn tunnel
  IPsec: show interface <name>
  IPsec: show inteface all
  L2 Interfaces: show interface all
  L2 Interfaces: show interface <int>
  L2 Interfaces: show interface management
  L2 Interfaces: show system state filter-pretty sw.dev.runtime.ifmon.port-states
  L3 Interfaces: show interface all
  L3 Interfaces: show interface <int>
  L3 Interfaces: show interface management
  MAC: show mac all

Task Support:
--------------------------------------------------

  Basic discovery:
    ✗ _helpers/vlanIntList
    ✓ ARP
    ✓ Device info
    ✓ Disable pagination
    ✗ FHRP
    ✓ Init
    ✓ L2 Interfaces
    ✓ L3 Interfaces
    ✓ MAC
    ✓ Neighbor discovery protocols
    ✓ Port-channels
    ✓ Routing table
    ✓ SN
    ○ STP
    ✓ Virtual Contexts
    ✓ Vlan

  Configuration:
    ✓ Config Current
    ○ Configuration saved
    ○ Startup config

  Hardware:
    ○ Chassis extenders
    ○ Cluster
    ✓ Environment - Power & Fan
    ○ POE
    ✗ Stacking
    ✓ Transceivers
    ○ VSS

  Management:
    ○ IP Flow
    ✓ NTP
    ✗ OAM - unidirectLinkDetection
    ✗ Port mirroring
    ○ ptp
    ✗ SNMP
    ✓ Syslog

  MPLS:
    ○ Circuit cross-connect
    ○ MPLS - LDP
    ○ MPLS forwarding
    ○ VPLS
    ○ VPWS

  Multicast:
    ○ MAC multicast address table
    ✗ MCAST - IGMP
    ○ MCAST - IGMP Snooping
    ✗ MCAST - MROUTE
    ✗ MCAST - PIM

  Other:
    ✗ pppoe

  QoS:
    ✗ Router QoS

  Routing:
    ✗ Route summary
    ✓ Vrf

  Routing protocols:
    ✓ BGP
    ○ EIGRP
    ○ IS-IS
    ✓ OSPF
    ✗ OSPFv3
    ✗ RIP

  SDN:
    ○ ACI
    ○ VXLAN

  SDWAN:
    ✗ sites

  Security:
    ✗ AAA
    ✗ ACL
    ○ DHCPv4 Snooping
    ○ DMVPN
    ✗ Error disabled interfaces
    ✓ IPsec
    ✗ NAT
    ✗ Object groups
    ○ Secured access ports
    ○ Storm control
    ✗ STP port security
    ✓ Zone firewall

  Wireless:
    ○ Wireless - AP
    ○ Wireless - AP List
    ○ Wireless - Client List
    ○ Wireless - Lan List

All Families from paloalto:
--------------------------------------------------
  paloalto <-- current

Legend: ✓=Full, ✗=Not Yet, ○=N/A